In this manual: Intelligent Variable Transmission (IVT) System
34steps
~204min
4/5difficulty
Tightening torque found on this page
Done 0 of 34
Special Service Tool
Tool Name / Number
Illustration
Description
Oil seal installer 09452 - 26100
Used for IVT transmission case and housing oil seal installation [2WD] (Used with the handle)
Oil seal installer 09453 - 3L241
Used for IVT transmission case oil seal installation [4WD] (Used with the handle)
Oil seal installer 09453 - 2W100
Used for IVT transmission housing oil seal installation [4WD] (Used with the handle)
Handle 09231 - H1100
Used with the oil seal installer
Installation
When ATF leakage occurs due to the damage of the differential oil seal, replace the seal with a new one.
When installing a new oil seal, use the handle (09231 - H1100) and specified oil seal installer. 2WD
IVT transmission case and housing : Oil seal installer (09452 - 26100)
4WD
IVT transmission case : Oil seal installer (09453 - 3L241)
IVT transmission housing : Oil seal installer (09453 - 2W100)
Check that the torque converter is correctly assembled.
Check the depth from the face of the converter housing to the torque converter with the torque converter is facing up. [Correct assembly condition] [Incorrect assembly condition]
If the torque converter protrudes, rotate the torque converter (A) using IVT mounting bolts to fit into the oil pump key.
When the torque converter is not normally assembled and the engine and the IVT are combined, a gap occurs between the engine block and the torque converter housing. If a gap occurs, remove the IVT and reassemble the torque converter in accordance with the oil pump key. Torque converter incorrect assembly Torque converter correct assembly
If the bolt is tightened while there is a gap, it can cause damage on the key (A) of oil pump gear. In this case, replace the IVT assembly after removing the mounting bolts.
Install the IVT by slowly raising the jack.
Be careful not to damage other nearby systems or parts when installing the IVT assembly.