Engine Electrical System
Troubleshooting
In this manual: Engine Electrical System
~6min read
Troubleshooting
|
| Suspected causes | Correction |
| Broken alternator main fuse | Replace alternator main fuse |
| Broken instrument cluster fuse | Replace instrument cluster fuse |
| Defective connection of wiring connector | Inspect wiring connection |
| Defective regulator or alternator | Replace regulator or alternator |
| Defective connection of battery terminal | Inspect tightening of positive ( + ) and negative ( - ) battery terminals to specified torque |
| Communication error | Inspect wiring between regulator and Engine Control Module (ECM). |
| Inspect transmit signal of ECM | |
| Inspect or replace alternator if wiring and ECM are normal |
Charging warning lamp does not turn off during engine running
| Suspected causes | Correction |
| Worn drive belt or lack of tension | Adjust the tension or replace of the drive belt |
| Defective connection, corroded or worn battery cable | Inspect connection of battery cable and repair or replace cable |
| Broken alternator main fuse | Replace alternator main fuse |
| Defective regulator or alternator | Replace regulator or alternator |
| Ignition wiring fault | Repair or replace the wiring |
| Defective instrument cluster | Inspect the instrument cluster and replace it if necessary |
| Slip in alternator pulley | Inspect or replace alternator pulley |
| Adjust the tension or replace of the drive belt | |
| Defective connection of battery terminal | Inspect tightening of positive ( + ) and negative ( - ) battery terminals to specified torque |
Charging warning lamp turns on
| Suspected causes | Correction |
| Slip, worn or lack of tension in drive belt | Adjust the tension or replace of the drive belt |
| Replace auto tensioner (only for auto tensioner type) | |
| Error in Alternator Management System (AMS) voltage | Connect the battery sensor and check for short circuits with the harness and body of the vehicle |
| Error in battery sensor | Inspect or replace battery sensor |
| Short between battery sensor wiring and body | Replace battery sensor |
| Warning light illuminating due to output power of the L terminal of the alternator | Replace alternator or regulator |
| Deterioration occurs due to poor positive ( + ) terminal contact | Inspect tightening of positive ( + ) battery terminal to specified torque |
| Internal pin of alternator that is connected with extension connector shorted | Repair the pin or inspect/replace the wiring |
| Short between the body and transaxle ground cable | Connect or repair ground cable |
| Communication error | Inspect wiring between regulator and ECM |
| Inspect transmit signal of ECM | |
| Inspect or replace alternator if wiring and ECM are normal | |
| A short circuit occurred in the harness connected to the alternator L terminal | Repair or replace wiring after inspection |
| Drive belt rotation stops due to slip in crankshaft damper pulley or defective pulley | Inspection/replace the crankshaft damper pulley or drive belt tensioner bearing |
| Defective regulator | Replace regulator |
| Defective alternator | Replace alternator |
| Broken alternator main fuse | Replace alternator main fuse |
| Defective ground | Inspect or repair ground |
Discharged battery
| Suspected causes | Correction |
| Worn drive belt or lack of tension | Adjust the tension or replace of the drive belt |
| Bad wiring connection and short circuit | Inspect connection of wiring and repair or replace wiring |
| Broken alternator main fuse | Replace alternator main fuse |
| Defective regulator or alternator | Replace regulator or alternator |
| Defective ground | Inspect or repair ground |
| Damaged and defective battery | Replace battery |
| Parasitic current exceeding the specified value | Repair or replace after measuring the parasitic current |
| Assembly fault and defective parts due to modification of electrical device | Repair the vehicle by using the genuine parts |
| Low state of charge | Learn or replace battery sensor |
| Battery wiring damaged or broken | Repair or replace wiring after inspection |
| Parasitic battery drain due to defective ECM main control relay | Inspect or replace ECM |
| Defective wiring harness due to moisture | Repair or replace wiring |
| Defective body electronic parts | Replace the body electronic parts |
| Parasitic battery drain due to defective ECM | Inspect or replace ECM |
| Defective connection of alternator connector | Connect the connector correctly |
Swollen battery
| Suspected causes | Correction |
| Defective battery | Inspect or replace battery |
| Defective regulator or alternator | Repair or replace after inspecting the regulator and alternator |
| Defective parts and wiring related to charging | Repair or replace the parts related to charging and wiring after inspection |
The battery does not charge properly during idling (normally charging during the acceleration)
| Suspected causes | Correction |
| Bad wiring connection and circuit | Inspect connection of wiring and repair or replace wiring |
| Defective connector pins connection | Inspect connection of wiring and repair or replace wiring |
Alternator main fuse blown frequently
| Suspected causes | Correction |
| Short or open in battery wiring | Check wiring connections and repair or replace wiring (If the battery wiring is normal, check the rest of the wiring) |
The charging warning light and other warning lights illuminate at the same time
| Suspected causes | Correction |
| short circuit occurred between the other warning lights and the alternator L terminal. ( L terminal type of the alternator applied vehicle only) | Repair or replace wiring after inspection |
Engine warning lamp on
| Suspected causes | Correction |
| Battery sensor bolt loosening | Tighten to specified torque |
Dimming headlights
| Suspected causes | Correction |
| Defective wiring and wiring connection | Inspect connection of wiring and repair or replace wiring |
Was this page helpful?