Kia Stonic Quiz
restraint system

Passenger Airbag ON/OFF Switch

In this manual: restraint system
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
11steps
~66min
3/5difficulty
Done 0 of 11

Description and Operation

Description

The driver can check the operating status of the front passenger airbag (ON or OFF) with this passenger airbag switch.

The passenger airbag ON/OFF switch (PAB) is installed on the side of the instrument panel.

Components and Components Location

COMPONENTS LOCATION

repair procedures

expansion

  1. Remove the ignition key.

  2. Disconnect the battery negative terminal and wait at least three minutes before starting work.

  3. Remove the instrument panel side trim (A).

  4. Disconnect the connector of the passenger airbag module ON/OFF switch (A) (PAB).

  5. Disconnect the connector of the passenger airbag module ON/OFF switch (PAB).

Installation

  1. Remove the ignition key.

  2. Disconnect the battery negative terminal and wait at least three minutes before starting work.

  3. Install the passenger airbag module ON/OFF switch (PAB) into the side impact protector cover.

  4. Connect the connector of the passenger airbag module ON/OFF switch (PAB).

  5. Install the instrument panel side trim.

    (Refer to Body — "Instrument Panel Side Trim")

  6. Perform a functional check after installing the SRSCM:

    • Turn the ignition on. The SRS indicator should light up for about 6 seconds during initialization, then turn off.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.