Kia Stonic Quiz
restraint system

Seat Belt Anchor Bolt (BS)

In this manual: restraint system
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
7steps
~42min
2/5difficulty
Done 0 of 7

Description and Operation

Description

The SRSCM monitors the status of the driver and front passenger seat belt buckles. Accordingly, a contact in the SRSCM is designed to input the status signal of the driver and front passenger seat belt buckles. The seat belt buckle circuit operates with an internal elevated voltage supplied by the SRSCM and uses body ground for signal return. Activation by the SRSCM depends on the buckle status. If the seat belt is not fastened, the corresponding seat belt pretensioner is not deactivated.

Components and Components Location

COMPONENTS LOCATION

1. Seat Belt Buckle Switch (BS)

repair procedures

expansion

  1. Disconnect the battery ground cable and wait at least three minutes before starting work.

  2. Remove the front seat.

    (Refer to Body - "Front Seat Assembly")

  3. Loosen the mounting bolt, then remove the seat belt buckle switch (A).

Installation

  1. Disconnect the battery ground cable and wait at least three minutes before starting work.

  2. Installation is the reverse of removal.

  3. Reconnect the battery negative (-) cable.

  4. After installing the seat belt buckle switch, check its operation:

    • Turn the ignition on; the SRS indicator should illuminate for 6 seconds during initialization, and then go off.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.