Kia Stonic Quiz
restraint system

Side Impact Sensor (SIS)

In this manual: restraint system
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
9steps
~54min
2/5difficulty
0102030405043N·mlb·ft
Tightening torque found on this page
Done 0 of 9

Beschreibung und bedienung

Beschreibung

  • The Side Impact Sensor (SIS) system consists of two pressure side impact sensors (P-SIS), located in the center of the two front door modules (left and right), two SIS located in the B-pillars (left and right), and two rear SIS located in the C-pillars (left and right).

  • The pressure side impact sensor, also called P-SIS, detects pressure in a collision at its mounting position.

  • The side impact sensor, also called A-SIS, detects acceleration forces.

  • In a collision, the SRSCM determines whether the airbag will deploy based on the collision signal from the SIS, and sets the timing of deployment.

Bauteile und bauteile-Übersicht

BAUTEILE-ÜBERSICHT

1. Pressure Side Impact Sensor (P-SIS)
2. Front Impact Acceleration Sensor (G-SIS)

Repair Procedures

REMOVAL AND INSTALLATION

Pressure Side Impact Sensor (P-SIS)

  1. Batteriemasseklemme abklemmen und vor Beginn der Arbeiten mindestens dreißig Sekunden warten.

  2. Vordere Türverkleidung abbauen.

    (Siehe Karosserie - "Vordertürverkleidung")

  3. Remove the pressure side impact sensor (A).

  4. Loosen the side pressure impact sensor mounting bolt and remove the sensor (A).

    Anzugsdrehmoment: 3,0 - 4 N·m

  5. Der Einbau erfolgt in der umgekehrten Reihenfolge des Ausbaus.

Front Impact Acceleration Side Sensor (G-SIS)

  1. Batteriemasseklemme abklemmen und vor Beginn der Arbeiten mindestens dreißig Sekunden warten.

  2. B-Säulenverkleidung abbauen.

    (Siehe Karosserie - "B-Säulenverkleidung")

  3. Steckverbinder (A) des Seitenaufprallsensors abziehen und Schraube (B) lösen, dann Sensor entfernen.

    Anzugsdrehmoment: 3,0 - 4 N·m

  4. Der Einbau erfolgt in der umgekehrten Reihenfolge des Ausbaus.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.