Kia Stonic Quiz
Electrochromic Interior Rear View Mirror

Rear Combination Lamp

In this manual: Electrochromic Interior Rear View Mirror
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
27steps
~162min
4/5difficulty
Done 0 of 27

repair procedures

expansion

Rear Combination Lamp (Outside)

  1. Disconnect the battery ground cable.

  2. Loosen the mounting screws and remove the rear combination lamp (A).

  3. Remove the rear combination lamp gasket (A).

  4. Disconnect the rear combination lamp connector (A).

Bulb Replacement

Turn signal lamp

  1. Turn off the headlight switch.

  2. Remove the rear combination lamp (Outside).

  3. Turn the turn signal lamp socket (B) counterclockwise (A) and remove it.

Rear Combination Lamp (Inside)

  1. Disconnect the battery ground cable.

  2. Remove the rear combination lamp cover (A) using a screwdriver or a remover.

  3. Loosen the nuts, then disconnect the connector (B) and remove the rear combination lamp (A).

Back-up Lamp

  1. Disconnect the battery ground cable.

  2. Remove the rear bumper.

    (See Body - Rear Bumper)

  3. Disconnect the back-up lamp connector (A).

  4. Loosen the mounting screws and remove the back-up lamp (A).

Bulb Replacement

Back-up Lamp

  1. Disconnect the battery ground cable.

  2. Disconnect the back-up lamp connector (A).

  3. Remove the back-up lamp bulb (B) by turning the socket (A) counterclockwise.

Installation

Rear Combination Lamp (Outside)

  1. Connect the rear combination lamp connector.

  2. Install the rear combination lamp.

  3. Connect the negative (-) battery terminal.

Rear Combination Lamp (Inside)

  1. Install the rear combination lamp.

  2. Connect the rear combination lamp connector.

  3. Install the rear combination lamp cover.

  4. Connect the negative (-) battery terminal.

Back-up Lamp

  1. Tighten the back-up lamp.

  2. Install the rear bumper.

  3. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.