Kia Rio YB Quiz
Automatic Transmission

Overdrive Clutch Control Solenoid Valve (PCSV-A)

In this manual: Automatic Transmission
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
8steps
~48min
2/5difficulty
0102030405011.89N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Specifications

Specification

Item Specification
Type Normally open
Input voltage 12 V
Coil Resistance 3.5 ± 0.2 Ω (at 25 °C, 77°F)
Frequency 50 Hz

Components and Component Location

Component Location

1. Overdrive Clutch Control Solenoid Valve (PCSV-A)
2. On/Off Solenoid Valve (SCSV-A)
3. Torque Converter Control Solenoid Valve (PCSV-D)
4. Underdrive Clutch Control Solenoid Valve (PCSV-C)
5. 2-4 Brake Control Solenoid Valve (PCSV-B)
6. Solenoid Valve Support Bracket

Description and Operation

Description

  • The overdrive clutch control solenoid valve is a PWM (Pulse Width Modulation) type.

  • When the TCM supplies current to the solenoid valve, the hydraulic pressure of the OD clutch and LR brake is controlled by the solenoid valve.

Solenoid Valve Operation Table

Range PCSV-A
N, P
1 ●
2 ●
3
4
R

Circuit Diagrams

Wiring Diagram

Repair Procedures

Inspection

  1. Turn the ignition off.

  2. Remove the air cleaner.

    (Refer to Engine Mechanical System - "Air Cleaner")

  3. Disconnect the main connector (A).

  4. Measure the resistance between the ground terminal (7) and the signal terminal (1).

    Specification: 3.5 ± 0.2 Ω

Removal

  1. Remove the valve body assembly

    (Refer to Hydraulic System - "Valve Body")

  2. Disconnect the main harness (A).

  3. Remove the solenoid valve support bracket (A) after loosening the bolts.

    Tightening Torque: 9.8–11.8 N·m

  4. Remove the overdrive clutch control solenoid valve (A).

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.