Transmission & Driveline

Additional Service When Replacing Transmission Assembly

6steps
~36min
4/5difficulty
Done 0 of 6

Description

When replacing the transmission assembly, perform the following work. For work procedure, refer to Work Procedure.

WORK AFTER TRANSMISSION ASSEMBLY REPLACEMENT

  • Vehicle specifications writing

  • Calibration of decel G sensor

Work Procedure

REPLACE A/T ASSEMBLY

Replace A/T assembly. Refer to Removal and Installation (2WD) or Removal and Installation (4WD).

>>

GO TO 2.

WRITING vehicle SPECIFICATIONS

With CONSULT

  1. Ignition switch ON.

  2. Select "TRANSMISSION".

  3. Select "Replace ECU".

  4. Perform the work according to the procedure displayed in CONSULT.

  • Turn the ignition switch OFF and wait until the combination meter turns off. Then turn the ignition switch ON.

  • Disconnect the 12V battery terminal and reconnect it. Then turn the ignition switch ON. Refer to Precautions for Removing Battery Terminal.

>>

GO TO 3.

CALIBRATE DECEL G SENSOR

  1. Perform decel G sensor calibration. Refer to Description.

  2. Clear any DTCs that may have set and then test drive the vehicle.

>>

WORK END