Transmission & Driveline
Torque Converter and Converter Housing Oil Seal
In this manual: Transmission & Driveline
~1min read
Exploded View

| A/T assembly | Converter housing oil seal | Seal ring | |||
| Torque converter | |||||
| : Always replace after every disassembly. | |||||
| : Apply ATF | |||||
Removal and Installation
REMOVAL
Remove A/T assembly. Refer to Removal and Installation (2WD), Removal and Installation (4WD).
Remove torque converter by holding it firmly and turning while pulling straight out.
Remove seal ring from input shaft.
Remove converter housing oil seal.
INSTALLATION
Installation is in the reverse order of removal.
Check dimension (A) between torque converter and torque converter housing as shown.

Dimension (A) : Refer to Torque Converter. (B) : Scale (C) : Straight edge
Adjustment
ADJUSTMENT AFTER INSTALLATION
When replaced the torque converter, perform "TORQUE CONVERTER CLUTCH POINT LEARNING". Refer to Descripton.
Was this page helpful?