Transmission & Driveline
Oil Pan
In this manual: Transmission & Driveline
~2min read
Exploded View

| A/T assembly | Oil pan gasket | Overflow tube | |||
| O-ring | Oil pan | Drain plug | |||
| O-ring | O-ring | ||||
| Refer to Removal and Installation. | |||||
| : Always replace after every disassembly. | |||||
| : Apply ATF | |||||
Removal and Installation
REMOVAL
Disconnect the negative battery terminal. Refer to Removal and Installation.
Drain A/T fluid. Refer to Draining.
Remove oil pan mounting bolts (
) and then remove oil pan
.

| : Front |
Remove oil pan gasket
.

Remove O-rings
from oil pan strainer.

Disengage pawls and remove overflow tube
from oil pan.

| : Pawl |
Remove O-ring
from drain plug.

INSTALLATION
Note the following, and install in the reverse order of removal.
Align the cut outs
of overflow tube and oil pan when Installing overflow tube
to oil pan.
Place oil pan gasket alignment tab
in the oil pan alignment hole 

Tighten oil pan mounting bolts to specification shown.
Step 1 : Tighten 4 N·m Step 2 : Tighten 95° Fill with A/T fluid after installation. Refer to Refilling.
Was this page helpful?