Transmission & Driveline

Electric Shift Selector

7steps
~42min
4/5difficulty
Done 0 of 7

Exploded View

Front center console switch finisher assembly Electric shift selector

Removal and Installation

Removal

Remove front center console switch finisher assembly from center console assembly. Refer to Removal and Installation.

Remove electric shift selector mounting screws and remove electric shift selector from front center console switch finisher assembly.

Installation

Note the following, and install in the reverse order of removal.

  • When installing the electric shift selector to the front center console switch finisher assembly, perform the following procedure.

    1. Push the electric shift selector until it engages to the front center console switch finisher assembly locator pin .

    2. Tighten the electric shift selector mounting screws in the order as shown in the figure.

      : vehicle front
    3. Connect electric shift sensor harness connector.

  • Perform inspection after installation. Refer to Inspection.

Inspection

Inspection after Installation

Shift Button Operation

Check the shift button operation status according to the following procedure. When there is malfunction, repair or replace the electric shift selector.

  1. Check that each shift button is smoothly operated without any twisting, catching, noise, or others by pressing each one.

  2. Check that each shift button returns to the original position after pressing each one without catching.

SHIFT POSITION

Check the shift operation status in READY state according to the following procedure. When there is malfunction, perform inspection for the electric shift system.

  1. Check that the shift position changes to the position corresponding to the shift button, when pressing each shift button while the brake pedal is depressed.

  2. Check that the shift position does not change from P position, even if each shift button is pressed without depressing the brake pedal while the shift position is P.

  3. Check that the back-up lamp lights up when the shift position is set to R.

  4. Check that the shift position changes to M, when pressing D/M button while the shift position is D.

  5. Check that the shift position changes to D, when pressing D/M button while the shift position is M.