Information display (speed limiter)
Component Function Check
1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch.3. Drive the vehicle at more than 30 km/h.
CAUTION:Always drive vehicle at a safe speed. 4. Press SET/− switch.
5. Perform a test drive on a flat road conditions. Check that the speedometer indicated the same value as the set speed indicator on the information display while depressing the accelerator pedal until just before a kickdown occurs.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to EC-435, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTCCheck that DTC UXXXX, P0500 or P1574 is not displayed.
Is the inspection result normal? YES >> GO TO 2.
NO-1 >> Perform trouble diagnosis for DTC UXXXX.
NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-286, "DTC Logic".
NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-352, "DTC Logic".
2.CHECK DTC WITH COMBINATION METERRefer to MWI-23, "CONSULT-III Function".
Is the inspection result normal? YES >> GO TO 3.
NO >> Perform trouble diagnosis for DTC indicated.
3.CHECK INTERMITTENT INCIDENTPerform GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".
NO >> Repair or replace error-detected parts.