Engine Control System MR16DDT
P158A ECM
In this manual: Engine Control System MR16DDT
~1min read
DTC Logic

*: Since this DTC is detected when G sensor calibration is incomplete, there is not replacement parts.
1.PRECONDITIONINGIf DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON.3. Turn ignition switch OFF and wait at least 10 seconds.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON.2. Check DTC.
Is DTC detected? YES >> Proceed to EC-354, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.PERFORM CALIBRATION OF G SENSORPerform calibration of G sensor. Refer to EC-138, "Work Procedure".
>> INSPECTION END
Was this page helpful?