Engine Control System MR16DDT
P062B ECM
In this manual: Engine Control System MR16DDT
~1min read
Description
This DTC is detected when the ECM-integrated injector driver unit has a malfunction. For injector driver unit, refer to EC-31, "ECM".
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON.3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:Before performing the following procedure, confirm that battery voltage is 11 V or more at idle
.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE 1. Start the engine and keep the engine speed at idle for 30 seconds.2. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Proceed to EC-306, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK FUEL INJECTORCheck fuel injector. Refer toEC-400, "Component Function Check".
Is inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Erase DTC. 3. Perform DTC confirmation procedure again. Refer to EC-306, "DTC Logic".4. Check 1st trip DTC.
Is the DTC P062B displayed again? YES >> Replace ECM. Refer to EC-447, "Removal and Installation".
NO >> INSPECTION END
Was this page helpful?