SPEED LIMITER MAIN SWITCH
Component Function Check
1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION
With CONSULT-III
1. Turn ignition switch ON. 2. Select “SL MAIN SW” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III.
3. Check “SL MAIN SW” indication as per the following condition.

Without CONSULT-III
1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector and ground as per the following conditions.

Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to EC-432, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK SPEED LIMITER MAIN SWITCH POWER SUPPLY 1. Turn ignition switch OFF. 2. Disconnect combination switch (spiral cable) harness connector. 3. Turn ignition switch ON.4. Check the voltage between combination switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO >> Perform the trouble diagnosis for power supply circuit.
2.CHECK SPEED LIMITER MAIN SWITCH INPUT SIGNAL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect ECM harness connector.3. Check the continuity between ECM harness connector and combination switch harness connector.

4. Also check harness for short to ground and to power.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace error-detected parts.
3.CHECK ASCD STEERING SWITCHCheck the ASCD steering switch. Refer to EC-433, "Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace ASCD steering switch. Refer to ST-9, "Exploded View".
Component Inspection
1.CHECK ASCD STEERING SWITCH-I 1. Disconnect combination switch (spiral cable) harness connector.2. Check the continuity between combination switch harness connector terminals as per the following conditions.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace ASCD steering switch. Refer to ST-9, "Exploded View".
2.CHECK ASCD STEERING SWITCH 1. Disconnect combination switch (spiral cable) harness connector.2. Check the resistance between combination switch harness connector terminals as per the following conditions.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace ASCD steering switch. Refer to ST-9, "Exploded View".