Engine Control System MR16DDT
P0201, P0202, P0203, P0204 fuel injector
In this manual: Engine Control System MR16DDT
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PRECONDITIONINGIf DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON.3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:Before performing the following procedure, conform that battery voltage is 11 V or more at idle.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Start the engine and let it idle at least 30 seconds.3. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Proceed to EC-253, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.PERFORM TROUBLE DIAGNOSIS FOR INJECTORPerform trouble diagnosis for injector. Refer to EC-400, "Component Function Check".
Is inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Repair or replace error-detected parts.
Was this page helpful?