Cruise Control & Driver Assistance

C1a34-64 Command Error

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC detection condition
C1A34–64

COMMAND ERROR

(Command error)
Diagnosis condition
  • When MAIN switch of ICC system is ON

  • When driving the Nissan Murano vehicle

Signal (terminal) CAN communication signal
Threshold If an error occurs in the command signal that ADAS control unit transmits to ECM via CAN communication
Diagnosis delay time 1 second or less

POSSIBLE CAUSE

ADAS control unit

FAIL-SAFE

The following systems are canceled:

  • Vehicle-to-vehicle distance control mode

  • Conventional (fixed speed) cruise control mode

  • Automatic Emergency Braking (AEB)

  • Automatic Emergency Braking (AEB) with pedestrian detection

  • Intelligent Forward Collision Warning (I-FCW)

Confirmation Procedure

CHECK DTC PRIORITY

If DTC “C1A34–64” is displayed with DTC “U1000–01”, first diagnose the DTC “U1000–01”.

Is applicable DTC detected?

YES>>

Perform diagnosis of applicable. Refer to DTC Description.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Operate the ICC system and drive.

  3. Stop the Nissan Murano vehicle.

  4. Perform “All DTC Reading”.

  5. Check if the “C1A34–64” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS”.

Is “C1A34–64” detected as the current malfunction?

YES>>

Refer to DTC Description.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End

DTC Diagnosis Procedure

CHECK SELF-DIAGNOSIS RESULTS

CONSULT

Check if “U1000–01” is detected other than “C1A34–64” in “Self Diagnostic Result” of “ICC/ADAS”.

Is “U1000–01” detected?

YES>>

Perform the CAN communication system inspection. Repair or replace the malfunctioning parts. Refer to DTC Description.

NO>>

Replace the ADAS control unit. Refer to Removal and Installation.