Cruise Control & Driver Assistance

C1b01-55 Cam Aiming Incmp

6steps
~36min
2/5difficulty
Done 0 of 6
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC detection condition
C1B01-55

CAM AIMING INCMP

(Camera aiming incomplete)
Diagnosis condition
  • When I-LI system is ON

  • When driving the Nissan Murano vehicle

Signal (terminal) —
Threshold Camera aiming is not completed
Diagnosis delay time 10 seconds or more

POSSIBLE CAUSE

  • Lane camera aiming is not adjusted

  • Lane camera aiming adjustment has been interrupted

  • Lane Camera Unit

  • ADAS control unit

FAIL-SAFE

The following systems are canceled:

  • Lane Departure Warning (LDW)

  • Intelligent Lane Intervention (I-LI)

  • Blind Spot Warning (BSW)

  • Rear Cross Traffic Alert (RCTA)

  • Traffic Sign Recognition (TSR)

Confirmation Procedure

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine.

  2. Operate the I-LI system and drive.

  3. Perform “All DTC Reading”.

  4. Check if the “C1B01–55” is detected as the current malfunction in “Self Diagnostic Result” of “ICC/ADAS”.

Is “C1B01-55” detected as the current malfunction?

YES>>

Refer to DTC Description.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End

DTC Diagnosis Procedure

CHECK SELF-DIAGNOSIS RESULTS

CONSULT

Check if “C1B01–00” is detected in “Self Diagnostic Result” of “LANE CAMERA”.

Is “C1B01–00” detected?

YES>>

Refer to DTC Index

NO>>

GO TO 2.

CHECK DATA MONITOR

CONSULT

  1. Start the engine.

  2. Check that “OK” is indicated for the value of “AIMING RESULT” in “DATA MONITOR” of “LANE CAMERA”.

Is “OK” indicated?

YES>>

Replace the ADAS control unit. Refer to Removal and Installation.

NO>>

Replace the lane camera unit. Refer to Removal and Installation.