Cruise Control & Driver Assistance

C1a40-23 System Switch Circuit

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content)
DTC detection condition
C1A40-23

SYSTEM SW CIRC

(Lane intervention switch circuit)
Diagnosis condition When Ignition switch is ON.
Signal (terminal) —
Threshold Lane intervention switch circuit remains “ON” (short circuit) for 10 minutes or more
Diagnosis delay time —

POSSIBLE CAUSE

  • Lane intervention switch circuit

  • Lane intervention switch

  • ADAS control unit

FAIL-SAFE

The following systems are canceled:

  • Lane Departure Warning (LDW)

  • Intelligent Lane Intervention (I-LI)

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Start the engine and wait for approximately 10 minutes or more.

  2. Select “All DTC Reading” mode.

  3. Check if “C1A40–23” is detected as the current malfunction in “Self Diagnostic Result” mode of “ICC/ADAS”.

Is “C1A40–23” detected as the current malfunction?

YES>>

Refer to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK LANE INTERVENTION SWITCH CIRCUIT FOR OPEN

  1. Disconnect the ADAS control unit and lane intervention switch connectors.

  2. Check continuity between the ADAS control unit harness connector and lane intervention switch harness connector.

    ADAS control unit Lane intervention switch Continuity
    Connector Terminal Connector Terminal
    M182 23 M183 1 Yes

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace harness or connector.

CHECK LANE INTERVENTION SWITCH CIRCUIT FOR SHORT

Check continuity between the ADAS control unit harness connector and ground.

ADAS control unit Ground Continuity
Connector Terminal
M182 23 No

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connector.

CHECK LANE INTERVENTION SWITCH

Check lane intervention switch. Refer to Component Inspection.

Is the inspection result normal?

YES>>

Replace the ADAS control unit. Refer to Removal and Installation.

NO>>

Replace the lane intervention switch. Refer to Removal and Installation.

Component Inspection

CHECK LANE INTERVENTION SWITCH

Check continuity of lane intervention switch terminals.

Lane intervention switch Condition Continuity
Terminals
1 2 When the lane intervention switch is pressed Yes
When the lane intervention switch is released No

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace the lane intervention switch. Refer to Removal and Installation.