Engine and peripherals
Specifications
In this manual: Engine and peripherals
~1min read



| DESIGNATION | MAKE/TYPE | SPECIAL NOTES | ||||||
| Control module | LUCAS | 25-way (when replacing the ECU, carry out a learning procedure of the full-throttle (PF) position of the load potentiometer) | ||||||
| Injection | - | Indirect | ||||||
| Injection pump | LUCAS DIESEL 8448B171 A/231A (F8Q 630) 8448B152 B/241B (F8Q 662) |
Rotary pump fitted with:
|
||||||
| Pump timing (top dead centre obtained using Ø 8 mm pin) | - | Dimension (X) on pump | ||||||
| Injector holder | LUCAS DIESEL LCR 6735 405 |
Tightening torque: 7 daN.m (injector to injector holder, and injector holder to cylinder head) | ||||||
| Instrumented injector holder (needle lift) | LUCAS DIESEL LDCR020011AA1 |
Tightening torque: 7 daN.m Resistance ≈ 105 Ω |
||||||
| Injectors | LUCAS DIESEL RDN OSDC 6902 |
Check: 130 barMaximum deviation: 8 bar |
||||||
| EGR solenoid valve | - | Voltage: 12 volts Resistance: 46 ± 5 Ω |
||||||
| Delivery pipes | - | Internal Ø: 2.5 mm Length: 330 ± 5 mm |
||||||
| Preheating relay box | - | With pre/post-heating function (control managed by the ECU) | ||||||
| Spark plugs | BERU Pencil glow plug |
Resistance: 0.8 Ω Tightening torque: 2 daN.m |
||||||
| TDC sensor | - | Resistance: 220 Ω | ||||||
| Fast idle solenoid valve | - | Voltage: 12 V Resistance: 46 Ω |
||||||
| Advance corrector | - | Voltage: 12 V Resistance: 11.5 Ω |
||||||
| Load potentiometer | - | Voltage: 5 V Resistance: (approx. in kΩ)
|
||||||
| Altitude corrector | - | Voltage: 12 V Resistance: 15.5 Ω |
||||||
| Diagnostic | Sheet No. 43 Code D34 Selector S8 |
- |
Test yourself
A quick Renault Kangoo quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?
bar