Renault Kangoo Quiz
Engine and peripherals

Advance solenoid valve

In this manual: Engine and peripherals
Renault Kangoo Driver's Manual — 100Mechanisms and accessories — 44Mechanisms and Accessories — 7Diagnostic — 61Bodywork — 85Electrical equipment — 31Engine and peripherals — 88Bodywork — 24Chassis — 56Renault Kangoo 2 Electric Owner's Manual — 21Transmission — 14Air conditioning — 26General vehicle information — 24Sealing and soundproofing — 1Trim and upholstery — 1
5steps
~30min
2/5difficulty
Done 0 of 5
Electrovanne d’avance
DEPOSE

REMOVAL

Disconnect the pump electrical connector.

Remove the two terminals for the advance solenoid valve from the 10-way pump connector.

D?Poser du connecteur de pompe 10 voies les deux cosses concernant l’?Lectrovanne d’avanc

To remove the pump connector terminals:

  1. Pull the yellow guide to release it from the terminals, then press the two tabs on either side of the connector.
  2. Remove the yellow guide.
  3. Pull on the wire to be removed.
  4. The terminal is held by two tabs, one on each side. Using a screwdriver, spread one tab (pulling on the wire prevents the tab from returning into place).
  5. Using a screwdriver, spread the other tab.

The terminal can come out of the connector.

Remove the protective sheath grouping the pump actuators.

Remove the protective cap from the solenoid valve.

Remove the solenoid valve using tool Mot. 997-01.

Déposer l’électrovanne en utilisant l’outil mot. 997-01
  1. Connector routing

INSTALLATION

IMPERATIVELY remove the small filter screen (3) from the bottom of the well using fine-nose pliers, and replace it with a new filter screen.

The outer part acts as a sealing gasket and is crushed when the actuator is tightened to torque.

Refit in order the seal (4) of the 'banjo' return fitting (5), the new actuator (1) fitted with its outer screen, and the two seals (6) and (7).

Tighten the actuator to a torque of 3 daN.m using socket Mot. 997-01.

Fit the new protection (2) onto the actuator.

Reconnect the two terminals in the connector.

Reconnect the connector.

Refit the wiring protective sheath and its retaining clip.

Bleed the diesel circuit using the priming pump before restarting the engine.

IMPERATIVE: clear the memory by entering G0**. Mandatory road test of the vehicle after the operation.

Déposer l’électrovanne en utilisant l’outil mot. 997-01
Electrovanne d’avance

Test yourself

A quick Renault Kangoo quiz: every answer comes with an explanation and a link to the manual page.