How to Use Troubleshooting
PRECAUTION / NOTICE / HINT
HINT:
*: Use the Techstream.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
|
CUSTOMER PROBLEM ANALYSIS
(a) Ask the customer questions and confirm the problem.
Click here
![]()
|
CHECK BATTERY VOLTAGE
Standard voltage:
11 à 14 V
- If the voltage is below 11 V, charge or replace the battery before proceeding to the next step.
|
CHECK DTCs AND FREEZE FRAME DATA*
(a) Check and record the DTCs and freeze frame data.
For DTC check / clear: Click here![]()
For freeze frame data: Click here![]()
(b) Clear the DTCs and freeze frame data.
For DTC check / clear: Click here![]()
(c) Check the DTCs again.
(1) Confirm the DTCs again based on the freeze frame data and the recorded DTCs.
Chassis > ABS/VSC/TRAC/EPB > Trouble Codes(2) Try to reproduce the symptoms of the problem based on the recorded DTCs and freeze frame data, then check whether the DTCs are output again.
Result:
Result | Proceed to |
|---|---|
DTCs are not output. (The problem symptom occurs.) |
A |
DTCs are output. |
B |
DTCs are not output. (The problem symptom does not occur.) |
C |
HINT:
- Refer to the diagnostic trouble code chart when DTCs are output.
- When DTCs indicating a CAN communication system malfunction are output, first troubleshoot and repair the CAN communication system.
| B | GO TO DIAGNOSTIC TROUBLE CODE CHART |
| C | USE SIMULATION METHOD TO CHECK |
|
SYMPTOM TROUBLESHOOTING TABLE
(a) Go to the Problem Symptoms Table.
Click here![]()
Result:
Result | Proceed to |
|---|---|
The malfunction is not listed in the Symptom Troubleshooting Table. |
A |
The malfunction is listed in the Symptom Troubleshooting Table. |
B |
| B | GO TO STEP 7 |
|
GENERAL ANALYSIS AND TROUBLESHOOTING*
(a) Refer to the ECU terminals.
Click here![]()
(b) Refer to Data List / Active Test.
Click here![]()
|
REPAIR OR REPLACE
|
CONFIRMATION TEST
| NEXT | END |