Precautions
PRECAUTION
IGNITION SWITCH TERMS
(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.
Term | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
Ignition Switch in OFF position |
LOCK |
OFF (Locked) |
Ignition Switch in ACC position |
ACC |
ON (ACC) |
Ignition Switch in ON position |
ON |
ON (IG) |
Starting the engine |
START |
ON (Starting) |
PRECAUTIONS FOR TROUBLESHOOTING
(a) When inspecting the rear brakes, disconnect the connector of the electric parking brake actuator assembly or disconnect the cable from the negative (-) battery terminal.
CAUTION:
- Do not inspect the rear brakes with the electric parking brake actuator assembly connector or the negative (-) battery terminal connected.

- The rear disc brake piston may operate, which could cause an accident such as your hands getting trapped.
(b) The electric parking brake may still operate for 20 seconds after the ignition switch is turned OFF. Before disconnecting any connectors or fuses, turn the ignition switch OFF and wait at least 20 seconds.
(c) If no component parts have been removed or installed, make sure the system operates normally by checking the DTCs after installation is complete.
PRECAUTIONS FOR HANDLING
(a) When the vehicle is parked on a level surface and then tilted to perform work, the braking force may not be sufficient. Be sure to pull the Electric Parking Brake Switch (Electric Parking Brake Switch Assembly) toward the lock side twice (2 lock operations).
HINT:
- The electric parking brake system determines the amount of force used to apply the parking brake based on the incline angle detected by the deceleration sensor (Airbag Sensor Assembly).
- When the parking brake warning light (red) comes on after the Electric Parking Brake Switch (Electric Parking Brake Switch Assembly) is pulled toward the lock side, the maximum braking force is applied if the Electric Parking Brake Switch (Electric Parking Brake Switch Assembly) is pulled toward the lock side again.
(b) The parking brake warning light flashes (red) when the ignition switch is turned ON after the Skid Control ECU (Brake Actuator Assembly) has been replaced. Operate the Electric Parking Brake Switch (Electric Parking Brake Switch Assembly) to turn off the parking brake warning light.
PRECAUTIONS FOR TOWING VEHICLES
(a) For towing precautions: Click here![]()
FORCED PARKING BRAKE RELEASE METHOD
(a) For the forced parking brake release method.
- TMC manufactured
Click here
.gif)
- TMMT manufactured
Click here
.gif)