Parking Brake

Check / Clear DTCs

~3min read
1special tools

CHECK / CLEAR DTCs

CHECK DTCs AND FREEZE FRAME DATA (USING TECHSTREAM)

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Select the following menu items: Chassis / ABS/VSC/TRAC/EPB / Trouble Codes.

Chassis > ABS/VSC/TRAC/EPB > Trouble Codes

(f) Check DTCs.

Click here

NOTICE:

The electric parking brake system outputs DTCs for the following system. When DTCs other than those in the Electric Parking Brake System DTC Chart are output, refer to the DTC chart for the corresponding system.

System

Proceed to

Vehicle Stability Control System

(g) Check the freeze frame data.

  1. IF DTCs are output, check the freeze frame data and note the vehicle status when the DTC was recorded.

HINT:

For freeze frame data: Click here

CLEAR DTCs AND FREEZE FRAME DATA (USING TECHSTREAM)

(a) Turn the ignition switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn on the Techstream.

(e) Select the following menu items: Chassis / ABS/VSC/TRAC/EPB / Trouble Codes.

(f) Clear DTCs.

Chassis > ABS/VSC/TRAC/EPB > Clear DTCs

HINT:

When DTCs are cleared, the freeze frame data is also cleared.

CHECKING DTCs (USING SST CHECK WIRE)

(a) Turn the ignition switch OFF.

(b) Using the SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST: 09843-18040

*1

DLC3

NOTICE:

Do not connect the wrong terminals, as this could damage the electrical system components.

(c) Turn the ignition switch ON, then read the DTCs from the number of flashes of the parking brake indicator (red).

HINT:

  • When the situation is normal, the indicator flashes at 0.25 second intervals.
  • If one code is detected:

    The indicator repeats the same code after a 4.5 second pause.

  • If multiple codes are detected:

    The indicator outputs one code after another with a 2.5 second pause between each code.

    After all codes are output, there is a 4.5 second pause and the indicator starts outputting the codes again.

  • If more than one malfunction is detected at the same time, the code with the lowest numerical value is displayed first.

(d) Check the DTC details.

Warning Light Display

Tester display

19

C13B0

35

C13B4

41

C13A5

42

C13A6

43

C13A7

71

C13AA

CLEAR DTCs (USING SST CHECK WIRE)

(a) Turn the ignition switch OFF.

(b) Using the SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST: 09843-18040

*1

DLC3

NOTICE:

Do not connect the wrong terminals, as this could damage the electrical system components.

(c) Turn the ignition switch to ON.

(d) Within 5 seconds, pull the Electric Parking Brake Switch Assembly toward the lock side 5 times.

NOTICE:

If the Electric Parking Brake Switch (Electric Parking Brake Switch Assembly) is pulled too quickly, the system may not respond. If the system does not respond, perform the operation again more slowly.

(e) Make sure a normal system code is output (the parking brake indicator flashes (red) at 0.25 second intervals).

HINT:

If the malfunction is present, the DTCs cannot be cleared.