Exterior Lighting

Removal

~1min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed or replaced during removal/installation of the rear height control sensor sub-assembly are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Rear LH Height Control Sensor Sub-assembly

Initialize LH Headlight ECU Sub-assembly

Automatic Headlight Leveling System

PROCEDURE

1. REMOVE REAR WHEEL (for LH side)

Click here

2. REMOVE REAR LH HEIGHT CONTROL SENSOR SUB-ASSEMBLY

(a) Disconnect the connector.

*a

Clip

*b

Hook

(b) Release the clip.

(c) Remove the 2 bolts.

(d) Release the hook to remove the rear LH height control sensor sub-assembly.

NOTICE:

If the rear LH height control sensor sub-assembly has been subjected to an impact or dropped, replace it with a new one.