Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR LH HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(a) Preparation for inspection
(1) Check the standard, high and low positions of the link that will be used in the following inspection.
- The standard position is 58° from the maximum link angle (high), and 51° from the maximum link angle (low).
- The high position (+33.85°) is 24.15° from the maximum link angle (high beam).
- The low position (-33.85°) is 17.15° from the maximum link angle (low).
*a |
Standard position |
*b |
Maximum link angle (low) |
*c |
Maximum link angle (high) |
*d |
51° |
*e |
58° |
*f |
-33,85° |
*g |
+33,85° |
- |
- |
(2) Connect 3 dry cell batteries (1.5 V) in series.
NOTICE:
Do not use rechargeable batteries as they may not output a voltage of 1.5 V.
(3) Connect the positive (+) battery cable to terminal 3 (SHB) and the negative (-) cable to terminal 1 (SHG).
*a |
Component without wire harness connected (rear LH height control sensor sub-assembly) |
*b |
Low |
*c |
Standard position |
*d |
High |
*e |
-33,85° |
*f |
+33,85° |
(4) Measure the voltage between terminal 2 (SHRR) and terminal 1 (SHG) while slowly moving the link up and down.
Standard voltage:
Tester Connection | Condition | Specified Condition |
|---|---|---|
1 (SHG) - 2 (SHRR) |
+33.85° (high beam) |
4,15 V |
1 (SHG) - 2 (SHRR) |
0° (standard position) |
2,5 V |
1 (SHG) - 2 (SHRR) |
-33.85° (low beam) |
1,04 V |
If the result is not as specified, replace the rear left height control sensor sub-assembly.