Exterior Lighting

Installation

~1min read
010203040505.44N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The following procedure applies to the left side.

PROCEDURE

1. INSTALL HEADLIGHT ASSEMBLY

(a) Temporarily install the headlight assembly as shown in the illustration.

Install in this direction

(b) Install the headlight assembly with the bolt and 3 screws.

Torque:

Bolt:

5.4 N·m {55 kgf·cm, 48 in·lbf}

(c) Connect the connector and raise the connector lock lever to engage the claw and lock the connector as shown in the illustration.

*a

Connector Lock Lever

Install in this direction

(d) Remove the protective tape.

2. INSTALL FRONT BUMPER ASSEMBLY

Click here

3. PERFORM INITIALIZATION

Click here

4. ADJUST HEADLIGHT AIM

Click here