Exterior Lighting

Inspection On Vehicle

~2min read

INSPECTION ON VEHICLE

PROCEDURE

1. INSPECT STOP LIGHT SWITCH ASSEMBLY

(a) Disconnect connector A45 from the stop light switch assembly.

*a

Front view of wire harness side connector

(to stop light switch assembly)

(b) Measure the voltage and resistance at the wire harness side connector according to the value(s) in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

A45-7 (B) - A45-2 (GND)

Ignition Switch in OFF position

11 à 14 V

A45-6 (B) - A45-2 (GND)

Ignition switch ON (IG)

11 à 14 V

Standard resistance:

Tester Connection

Condition

Specified Condition

A45-2 (GND) - Body ground

Always

Below 1 Ω

If the result is not as specified, repair or replace the wire harness or connector.

(c) Reconnect connector A45 to the stop light switch assembly.

*a

Component with Wire Harness Connected

(stop light switch assembly)

(d) Measure the voltage according to the value(s) specified in the table below.

Standard voltage:

Tester Connection

Condition

Specified Condition

A45-1 (OUT) - A45-2 (GND)

Ignition switch in OFF position, brake pedal released

Below 1 V

A45-1 (OUT) - A45-2 (GND)

Ignition switch in OFF position, brake pedal depressed

11 à 14 V

A45-3 (L) - A45-2 (GND)

Ignition switch in OFF position, brake pedal released

Below 1 V

A45-3 (L) - A45-2 (GND)

Ignition switch in OFF position, brake pedal depressed

11 à 14 V

A45-4 (ACC) - A45-2 (GND)

Ignition Switch in OFF position

11 à 14 V

A45-5 (L) - A45-2 (GND)

Ignition switch in ON (IG) position, brake pedal not depressed

11 à 14 V

A45-5 (L) - A45-2 (GND)

Ignition switch in ON (IG) position, brake pedal depressed

Below 1 V

If the result is not as specified, replace the stop light switch assembly.