Toyota Corolla Quiz
Engine Electrical Equipment

Ignition Coil

In this manual: Engine Electrical Equipment
Owner's Manual — 7Controls and Instruments — 49Engine Starting and Vehicle Operation — 5Actions if the Engine Does Not Start — 18Maintenance — 30Gasoline Engines - Repair Procedures Without Engine Removal from Vehicle — 17Gasoline Engines - Removal and Overhaul — 21Diesel Engine — 26Engine Electrical Equipment — 13Cooling and Heating Systems — 17Fuel and Exhaust Systems — 14Emission Control System — 19Manual transmission — 6Automatic transmission — 9Clutch and Axle Shafts — 11Brake System — 20Suspension and Steering — 24Body — 29Electrical System — 24Wiring Diagrams — 24
~1min read

Inspection

PROCEDURE
1. Disconnect the battery ground cable.
2. Remove the plastic coil cover.
3. Remove the two bolts securing the coil connector and connect the ohmmeter probes.

4. С помощью омметра измерьте сопротивление между положительным и отрицательным

4. Using the ohmmeter, measure the resistance between the positive and negative coil terminals (indicated by arrows). Compare the result with the specified value.

5. Измерьте сопротивление вторичной обмотки, т.е. между положительным выводом

5. Measure the resistance of the secondary winding, i.e. between the positive coil terminal and the high-tension terminal (indicated by arrows). Compare the result with the specified value.
6. If both resistance values differ from the specification, replace the ignition coil.

Replacement

PROCEDURE
1. Disconnect the battery ground cable.
2. Remove the heat shield from the coil.
3. Disconnect the leads from the coil, marking them beforehand. Remove the coil mounting screws.
4. Remove the coil mounting screws.
6. Install the coil in the reverse order of removal.

Test yourself

A quick Toyota Corolla quiz: every answer comes with an explanation and a link to the manual page.