Guide Wheels, Tyres - General Information

Run-flat tyre SST (Self Supporting Tyre)

2steps
~12min
1/5difficulty
Done 0 of 2

Run-flat tyres, general information

Compared with standard tyres, run-flat tyres have reinforced sidewalls. When pressure is lost, these reduce sidewall flexing and prevent the tyre sidewalls from being pinched. This keeps the vehicle controllable and gives almost normal handling. Fitting the spare wheel in sometimes dangerous situations, such as on the motorway or in poor weather conditions, is therefore unnecessary.

After a puncture, you can continue driving at an adjusted speed (maximum 80 km/h) and with an adjusted driving style as far as the next workshop (approx. 50 km), see → Owner's Manual.

In the event of a puncture, however, the driver is responsible for deciding, after checking the affected tyre(s), whether driving can continue.

-I- Tyre with normal air pressure

  1. Run-flat tyre (reinforced sidewall -red-)
  2. Standard tyre

-II- Tyre without air pressure

If the standard tyre -2- loses air, the rim compresses the sidewall extremely. When driving on a flat, the sidewall heats up strongly or is pinched and thereby destroyed.

In the run-flat tyre -1-, the reinforced sidewall (-red-) supports the tyre. Thanks to a special rubber compound and the lower flexing of the reinforced sidewall, the tyre does not heat up as much when rolling and the vehicle remains controllable.


Note

Observe the special conditions for using run-flat tyres.

VW UP. Ratgeber Räder, Reifen - Allgemeine Informationen

Run-flat tyres, retrofitting/conditions for using run-flat tyres


Caution!

Run-flat tyres may only be retrofitted to vehicles that are available with run-flat tyres as standard or optional equipment.

Since loss of pressure in run-flat tyres is not always visible to the naked eye, these tyres may only be used on vehicles with a tyre pressure monitoring system. This system warns the driver when the air pressure falls below a specified value.

Permitted are:

  • direct-measuring systems → Chassis, Axles, Steering;
  • indirect-measuring systems → Chassis, Axles, Steering;

Run-flat tyres may only be fitted to wheels with an extended double hump (Extended Hump - EH2).

The special fitting instructions must be observed.

Mixed fitment with standard tyres is not permitted, not even axle by axle.

Only in exceptional cases may a standard tyre be fitted for a short time or a limited distance. However, this removes the specific run-flat properties, and the driver must be expressly informed of this.

Be sure to observe the recommended tyre brands → Guide Wheels, Tyres;

Run-flat tyres, repair


WARNING!
  • Run-flat tyres must be replaced after running flat.
  • The special fitting instructions must be observed.

General Information

- As with conventional wheel and tyre systems, the wheel must also be checked before fitting.

- After a puncture, check the rim for damage: radial runout, lateral runout and other damage, as a pothole impact in an emergency may have damaged the rim.

- A damaged rim must be replaced with a new part.