Installation diagram for the four-door version

Check the status of the front
airbag before a passenger takes a seat or before installing a child seat.

Position where installing a child seat
is prohibited.

Child seat secured with the seat belt

Position where installing a
"Universal" approved child seat with the seat belt is permitted.

Position where installing a
"Universal" approved child seat with the seat belt is permitted only in the rear-facing position.

1. only if this position is equipped with an inertia-reel seat belt.

Child seat secured with ISOFIX anchorages

Position where ISOFIX child seat
attachment is permitted.

The rear seats are equipped with an
anchorage that permits installing a universal ISOFIX child seat facing forward. The anchorages
are located on the rear shelf under the cover.

The size of the ISOFIX child seat is indicated by a letter:

• A, B and B1: forward-facing group 1 seats (9 to 18 kg);
• C: rear-facing group 1 seats (9 to 18 kg);
• D and E: seats with a shell or rear-facing group 0 or 0+ seats (under 13 kg);
• F and G: group 0 cots (under 10 kg).

The table below contains the same information as the diagram on the previous page, to help you comply with applicable regulations.

Refer to the brochure "Child safety equipment", available on the brand's website, to select a seat suited to the child's height and weight and to the vehicle model.

X = Position not suitable for installing a child seat.

U = Position where a seat sold with "Universal" approval can be secured with the seat belt; check that it can be installed.

IUF = Position where a forward-facing child seat with "Universal" approval can be secured using ISOFIX; check that it can be installed.

IL = Position where a child seat with "semi-universal" or "vehicle-specific" approval can be secured using ISOFIX; check that it can be installed.

(3) Only a rear-facing child seat may be installed in this position: move the seat to its fully rearward and fully raised position, then recline the backrest slightly (approximately 25°).

(4) The cradle is installed sideways to the direction of travel and occupies at least two seats. Position the child's head on the side opposite the door.

(5) To install a rear-facing child seat, move the front passenger seat fully forward, then move it fully back, but not so far that it touches the child seat. Set the headrest to its highest position.

(6) For a forward-facing child seat, adjust the child seat backrest so that it contacts the vehicle seatback. Adjust the headrest height or extend it further if needed. Do not move the seat in front of the child rearward beyond the middle position of its adjustment rails. Do not recline the backrest too far (maximum 25°).