Ford Fiesta Quiz
Engine

Engine Oil Cooler. Removal and Installation

In this manual: Engine
Service Information — 27Suspension — 48Transmission — 9Brake System — 52Steering — 21Engine — 140Manual Transmission, Clutch, Transfer Case and Power Transfer Unit — 48Exhaust System — 6Fuel System — 21Climate Control System — 58Instrumentation and Warning Systems — 26Battery and Charging System — 20Infotainment Systems — 41Lighting — 29Power Distribution — 11Electronic Function Group — 30Body and Paint — 275Frame and Mounting — 3
5steps
~30min
2/5difficulty
0102030405014.511N·mlb·ft
Tightening torque found on this page
Done 0 of 5

Special Service Tools / General Equipment

Strap wrench
Oil Drain Equipment
Locking Pliers

Materials

Name Specification
Engine Oil — SAE 5W-20 — Semi-Synthetic Engine Oil
XO-5W20-Q1SP		 WSS-M2C945-B1

Removal

  1. Position the vehicle in NEUTRAL on the lift.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
  2. Remove and discard the engine oil filter.
    Use common service equipment: oil drain equipment.
    Use general service equipment: strap wrench.
    Material: Engine Oil — SAE 5W-20 — synthetic engine oil / XO-5W20-Q1SP (WSS-M2C945-B1)
    Torque: 128 lb-in (14.5 N·m)
  3. Loosen the hose clamps and disconnect the engine oil cooler coolant hoses.
    Use common service equipment: locking pliers.

  4. NOTICE: If metal or aluminum is present in the oil cooler, mechanical damage exists. Failure to correct these concerns may result in engine failure.

    For mechanical fault diagnosis.
    Remove the bolt and the engine oil cooler.
    Refer to: Engine (303-00 Engine System: General Information, Diagnosis and Testing).
    Torque: 41 lb-ft (55 N·m)
  5. Inspect the engine oil cooler.

Installation

  1. To install, reverse the removal procedure.

Test yourself

A quick Ford Fiesta quiz: every answer comes with an explanation and a link to the manual page.