Ford Fiesta Quiz
Engine

Rear Crankshaft Seal. Removal and Installation

In this manual: Engine
Service Information — 27Suspension — 48Transmission — 9Brake System — 52Steering — 21Engine — 140Manual Transmission, Clutch, Transfer Case and Power Transfer Unit — 48Exhaust System — 6Fuel System — 21Climate Control System — 58Instrumentation and Warning Systems — 26Battery and Charging System — 20Infotainment Systems — 41Lighting — 29Power Distribution — 11Electronic Function Group — 30Body and Paint — 275Frame and Mounting — 3
4steps
~24min
2/5difficulty
0102030405043N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Removal

  1. Remove the following components:
    1. Remove the flywheel.
      Refer to: Flywheel (Engine 303-01A — 1.6 L Duratec-16V Ti-VCT (88 kW/120 L PS) — Sigma, Removal and Installation).
    2. Remove the oil pan.
      Refer to: Oil Pan (Engine 303-01A — 1.6 L Duratec-16V Ti-VCT (88 kW/120 L PS) — Sigma, Removal and Installation).
  2. Remove the bolts and the rear crankshaft seal.

Installation

  1. Install the rear crankshaft seal and bolts in the specified sequence.
    Torque:
    Step 1: Tighten bolts 1 through 6 to: 35 lb-in (4 N·m)
    Step 2: Tighten bolts 1 through 6 to: 89 lb-in (10 N·m)
  2. Install the following components:
    1. Install the oil pan.
      Refer to: Oil Pan (Engine 303-01A — 1.6 L Duratec-16V Ti-VCT (88 kW/120 L PS) — Sigma, Removal and Installation).
    2. Install the flywheel.
      Refer to: Flywheel (Engine 303-01A — 1.6 L Duratec-16V Ti-VCT (88 kW/120 L PS) — Sigma, Removal and Installation).

Test yourself

A quick Ford Fiesta quiz: every answer comes with an explanation and a link to the manual page.