Engine Oil Pressure Sensor. Removal and Installation

Special Service Tools / General Equipment

Materials

Removal

1. 1
   Position the vehicle in NEUTRAL on the lift.
   Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
2. 2
   • Disconnect the resonator assembly hose. Loosen the clamps and remove the resonator assembly.
     Use general equipment: hose clamp removal/installation tool.

   • Loosen the clamps and set the CAC hose aside.

   

3. 3
   Disconnect the EVAP tube from the CAC outlet tube.

   

4. 4
   • Disconnect the electrical connector.

   • Remove the nut, loosen the clamp and remove the CAC outlet tube.

   

5. 5
   Remove and discard the oil filter.
   Use common service equipment: oil drain equipment.
   Use general service equipment: strap wrench.

   

6. 6
   Disconnect the EOP switch electrical connector.

   

7. 7
   Remove and discard the EOP switch.

   

Installation

1. 1
   Install a new EOP switch.
   Material: Motorcraft® PTFE Thread Sealant / TA-24-B (WSK-M2G350-A2)
   Torque: 159 lb-in (18 N·m)

   

2. 2
   Connect the EOP switch electrical connector.

   

3. 3
   Lubricate the new engine oil filter O-ring with clean engine oil and install it.
   Material: Engine Oil — SAE 5W-20 — synthetic engine oil / XO-5W20-Q1SP (WSS-M2C945-B1)
   Torque: 128 lb-in (14.5 N·m)

   

4. 4
   1. Install the CAC outlet tube and nut.
      Torque: 133 lb-in (15 N·m)

   2. Tighten the hose clamp and connect the electrical connector.
      Torque: 44 lb-in (5 N·m)

   

5. 5
   Connect the TP sensor electrical connector.

   

6. 6
   • Position the CAC hose and tighten the clamp.
     Torque: 44 lb-in (5 N·m)

   • Install the resonator assembly and connect the resonator assembly hoses.
     Use common service equipment: hose clamp removal/installation tool.