Hyundai Accent Quiz
Brake System

Bleeding the Brake Hydraulic System

In this manual: Brake System
Owner's Manual — 155SOHC Engines — 75DOHC Engines — 49Lubrication System — 14Cooling System — 23Emission Control — 3PCV Valve — 5Fuel system — 44Ignition System — 12Clutch — 17Manual transmission — 14Automatic transmission — 24Axle Shafts and Drive Shafts — 17Suspension — 31Steering — 45Brake System — 39Body — 23Air Conditioning System — 32Electrical Equipment — 54Appendix — 9Wiring Diagrams — 3
~1min read

PROCEDURE

1. Снимите крышку с компенсационного бачка с тормозной жидкостью.

1. Remove the cap from the brake fluid reservoir.

Brake fluid dissolves paint, plastic and wire insulation. If brake fluid gets on the painted surfaces of the vehicle or its components, wash them immediately with plenty of water.
Do not depress the brake pedal during pressure bleeding.

2. Remove the cap from the bleeder screw and connect one end of a transparent hose to it. Insert the other end of the hose into a glass container of sufficient volume, half filled with brake fluid.
3. Slowly depress the brake pedal several times.

4. При нажатой педали тормоза ключом ослабьте штуцер прокачки и выпустите воздух

4. With the brake pedal depressed, loosen the bleeder screw with a wrench and bleed air from the hydraulic system. Tighten the bleeder screw and release the brake pedal.
5. Repeat steps 3 and 4 until brake fluid without air bubbles flows out.
6. Tighten the bleeder screw.
Torque: 7–9 N·m

7. Удаление воздуха проводите в последовательности, показанной на рисунке.

7. Bleed air in the sequence shown in the illustration.

Test yourself

A quick Hyundai Accent quiz: every answer comes with an explanation and a link to the manual page.