Electrical Equipment

Antenna

~1min read

PROCEDURE

1. Disconnect the negative battery cable.

2. Снимите заднюю поперечную отделку и обивку с левой задней стороны багажника.

2. Remove the rear cross trim and the trim panel from the left rear side of the luggage compartment.

3. Отверните гайку крепления антенны и достаньте болт.

3. Remove the antenna mounting nut and remove the bolt.
Disconnect the antenna cable and the antenna power supply wires.
4. Install in the reverse order of removal.

Antenna Inspection

PROCEDURE

1. Disconnect the connector from the antenna.
2. Check that battery voltage is constantly supplied to pins 1 and 3 of the connector.

3. Проверьте, подается ли напряжение аккумуляторной батареи на контакты 1 и 2

3. Check that battery voltage is supplied to pins 1 and 2 of the connector when the ignition and radio are turned ON.
4. Using jumper wires, supply battery voltage to pins 3 and 2 and check whether the antenna motor operates (the antenna should extend).

5. Проверьте, работает ли двигатель антенны после отсоединения контакта 2 от

5. Check whether the antenna motor operates after disconnecting pin 2 from the battery (the antenna should retract).

Test yourself

A quick Hyundai Accent quiz: every answer comes with an explanation and a link to the manual page.