Engine Room Fuse Panel Fuse Replacement

■ Blade Fuse

■ Cartridge Fuse

1. Turn the ignition off.
2. Turn off all other switches.
3. Remove the fuse panel cover by pressing the tab and pulling up.
4. Check the removed fuse. Replace it if it is blown. To remove or insert a fuse, use the fuse puller in the engine compartment fuse block.
5. Insert a new fuse of the same rating and make sure it fits firmly in the clips. If it fits loosely, consult an authorized HYUNDAI service center.

NOTICE

After checking the engine compartment fuse panel, securely install the fuse panel cover. You may hear a click if the cover is securely latched. If it is not securely locked, electrical failure may occur due to water contact.

Main Fuse

1. Turn the engine off.
2. Turn off all other switches.
3. Remove the fuse panel cover by pressing the tab and pulling it up.
4. Remove the nuts shown in the figure above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.

Information

If the main fuse is blown, we recommend that you consult an authorized HYUNDAI repairer.

Multi Fuse

If the multi-purpose fuse is blown, it must be removed as follows:

1. Turn the ignition off.
2. Disconnect the negative battery cable.
3. Remove the fuse panel cover by pressing the tab and pulling it up.
4. Remove the nuts shown in the figure above.
5. Replace the fuse with a new one of the same rating.
6. Reinstall in the reverse order of removal.

Information

If the multi-purpose fuse is blown, we recommend that you consult an authorized HYUNDAI repairer.