Headlamp and Front Fog Lamp Aiming

Headlamp Aiming

1. Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire and tools.

2. Park the vehicle on a level floor.

3. Draw a vertical line (vertical line passing through the center of the corresponding lamp) and a horizontal line (horizontal line passing through the center of the headlamps) on the screen.

4. With the driver seated and the battery in normal condition, aim the headlamps so that the brightest part of the beam falls on the horizontal and vertical lines.

5. To aim the low beam left or right, turn the adjuster clockwise or counterclockwise. To aim the low beam up or down, turn the adjuster clockwise or counterclockwise. To aim the high beam up or down, turn the adjuster clockwise or counterclockwise.

Front Fog Lamp Aiming

The front fog lamp can be aimed in the same manner as the headlamps. With the driver seated and the battery in normal condition, aim the front fog lamps. To aim the front fog lamp up or down, turn the adjuster clockwise or counterclockwise.

Aiming Point

Low Beam Headlamp

1. Turn on the low beam without a driver in the vehicle.

2. The light-dark boundary line should project onto the light-dark boundary line shown in the illustration.

3. When aiming the low beam, the vertical aim should be adjusted after the horizontal aim adjustment.

4. If the headlamp leveling device is installed, set the leveling device switch to position 0.

Front Fog Lamp

1. Turn on the front fog lamp without a driver in the vehicle.

2. The light-dark boundary should project within the allowable range (hatched area).