Kia Forte BD Quiz
Body Electrical System

Turn Signal Indicator

In this manual: Body Electrical System
General Information — 8Maintenance — 32Engine Mechanical System — 47Engine Electrical System — 17Emission Control System — 10Engine Control System/Fuel System — 32Clutch System — 11Manual Transmission — 11DCT (Dual Clutch Transmission) System — 16Drive Shaft and Axle — 8Suspension System — 26Steering — 9Restraints — 11Brake System — 27Body (Interior and Exterior) — 119Body Electrical System — 98Heating, Ventilation, and Air Conditioning — 27
23steps
~138min
4/5difficulty
Done 0 of 23

Repair Procedures

Removal

Front turn signal lamp

  1. Disconnect the negative (-) battery terminal.

  2. Remove the front bumper assembly.

    (Refer to Body - "Front Bumper Assembly")

  3. Remove the front turn signal lamp (A) by loosening the screws after removing the wire clip (B).

Rear Turn Signal Lamp

  1. Disconnect the negative (-) battery terminal.

  2. Remove the rear bumper assembly.

    (Refer to Body - "Rear Bumper Assembly")

  3. Disconnect the rear turn signal lamp connector (A).

  4. Remove the front turn signal lamp (A) by loosening the screws.

Outside Mirror Turn Signal Lamp

  1. Disconnect the negative (-) battery terminal.

  2. Remove the mirror (A).

  3. Disconnect the mirror heater connector (A) and the BCW indicator connector (B).

  4. Remove the outside rearview mirror housing (A) and the outside rearview mirror cover (B) after loosening the screws.

  5. Remove the outside rearview mirror turn signal lamp (A) after loosening the screw.

  6. Remove the rubber seal (A).

  7. Disconnect the connector (A).

Installation

  1. Install in the reverse order of removal.

Replacement

Front Turn Signal Lamp

  1. Disconnect the negative (-) battery terminal.

  2. Remove the under cover.

    Nu 2.0 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")

    Gamma 1.6 MPI (Refer to Engine Mechanical System - "Engine Room Under Cover")

  3. Remove the front turn signal lamp socket (A) by turning it counterclockwise.

  4. Remove the bulb (A) from the socket.

  5. Install in the reverse order of removal.

Rear Turn Signal Lamp / Back-Up Lamp

  1. Disconnect the negative (-) battery terminal.

  2. Rear bumper protector (A).

    B: Clip

    C: Nut

    [LH]

    [RH]

  3. Remove the socket (A) by turning it counterclockwise, then remove the bulb (B) from the socket.

    [Back-Up Lamp]

    Rear Turn Signal Lamp

  4. Install in the reverse order of removal.

Test yourself

A quick Kia Forte BD quiz: every answer comes with an explanation and a link to the manual page.