Kia Stinger CK Quiz
Brake System

Brake Pedal

In this manual: Brake System
General Information — 8Maintenance — 27Engine Mechanical System — 47Engine Electrical System — 19Emission Control System — 12Engine Control System/Fuel System — 51Automatic Transmission System — 34All-Wheel Drive (AWD) System — 7Drive Shaft and Axle — 15Suspension System — 25Steering — 8Restraints — 19Brake System — 22Body (Interior and Exterior) — 47Front Seat Belt — 63Body Electrical System — 99Windshield Wiper/Washer — 11Heating, Ventilation, and Air Conditioning — 32
22steps
~132min
4/5difficulty
0102030405022.617N·mlb·ft
Tightening torque found on this page
Done 0 of 22

Components and Component Location

Components

1. Stop Lamp Switch 2. Brake Pedal

Repair Procedures

Removal

[Left-hand drive]

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.

  2. Remove the airbag lower panel.

    (Refer to Body - "Under Cover Panel")

  3. Remove the knee airbag.

    (Refer to Passive Safety System - "Knee Airbag (KAB) Module").

  4. Remove the lock pin (A) and the flat head pin (B).

  5. Disconnect the stop lamp switch connector.

    (Refer to Brake System - "Brake Pedal Switch")

  6. Loosen the brake pedal stopper nuts and remove the brake pedal stopper.

  7. Remove the brake booster mounting nuts (A).

    Tightening torque: 16.7–23 N·m

  8. Remove the upper brake pedal bolt, then remove the brake pedal assembly.

    Tightening torque: 16.7–26 N·m

[Right-hand drive]

  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.

  2. Remove the airbag lower panel.

    (Refer to Body - "Under Cover Panel")

  3. Remove the knee airbag.

    (Refer to Passive Safety System - "Knee Airbag (KAB) Module").

  4. Remove the Integrated Central Control Unit (ICU).

    (Refer to Body Electrical System - "Relay Box (Passenger Compartment)")

  5. Remove the lock pin (A) and the flat head pin (B).

  6. Disconnect the stop lamp switch connector (A).

  7. Loosen the brake pedal stopper nuts and remove the brake pedal stopper (A).

  8. Remove the brake booster mounting nuts (A).

    Tightening torque: 16.7–23 N·m

  9. Loosen the upper brake pedal bolt (A).

    Tightening torque: 16.7–26 N·m

  10. Remove the brake pedal assembly (A).

Inspection

  1. Inspect the bushing for wear.

  2. Inspect the brake pedal for bending or twisting.

  3. Inspect the brake pedal return spring for damage.

  4. Inspect the stop lamp switch.

    (Refer to Brake System - "Stop Lamp Switch")

Installation

  1. Install in the reverse order of removal.

Test yourself

A quick Kia Stinger CK quiz: every answer comes with an explanation and a link to the manual page.