Brake Line

Components and Component Location

Components

Repair Procedures

Removal

1. 1

   Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2. 2

   Remove the brake fluid from the master cylinder reservoir using a syringe.

3. 3

   Remove the wheel nuts, front/rear wheel and tire (A) from the front/rear hub.

   Tightening torque: 107.9–128 N·m

   

   [Front]

4. 4

   Loosen the flare nut (A) and disconnect the tube.

5. 5

   Disconnect the brake hose clip (B).

   Tightening torque: 13.7 - 16.7 N·m

   

   [Rear]

6. 6

   Loosen the flare nut (A) and disconnect the tube.

7. 7

   Disconnect the brake hose clip (B).

   Tightening torque: 13.7 - 16.7 N·m

   

8. 8

   Loosen the front/rear brake caliper hose bolt (A).

   Tightening torque: 24.5–29 N·m

   

Inspection

1. 1

   Inspect the brake tubes for cracks, bends and corrosion.

2. 2

   Inspect the brake hoses for cracks, damage and fluid leaks.

3. 3

   Inspect the tube flare nuts for damage and fluid leaks.

4. 4

   Inspect the brake hose mounting bracket for cracks or deformation.

Installation

1. 1

   Install in the reverse order of removal.

2. 2

   After installation, bleed the brake system.

   (Refer to Brake System - "Brake Bleeding Procedures")

3. 3

   Inspect for spilled brake fluid.