Kia Stonic Quiz
Electrochromic Interior Rear View Mirror

Power Door Lock Module

In this manual: Electrochromic Interior Rear View Mirror
General Information — 8Maintenance — 31Engine Mechanical — 49Engine Electrical — 15Emission control system — 11Engine Control System/Fuel System — 45Clutch System — 12Manual Transaxle System — 11DCT (Dual Clutch Transmission) System — 16Drive Shafts and Axles — 9Suspension — 16Steering — 10restraint system — 15Braking system — 22Body (Interior and Exterior) — 89Rear Seat — 16Electrical System — 25Electrochromic Interior Rear View Mirror — 64Heating, Ventilation, and Air Conditioning — 31
12steps
~72min
3/5difficulty
Done 0 of 12

Components and Components Location

COMPONENTS LOCATION

1. Door Lock/Unlock Button Cable 2. Door Lock

repair procedures

TEST

Front Door Lock Module Inspection

  1. Remove the front door panel.

    (See Body - Front Door Panel)

  2. Remove the front door panel seal.

    (See Body - Front Door Window Glass)

  3. Disconnect the actuator connector.

    [Central Door Lock Motor]

    No. Connector Terminal Function
    LEFT RIGHT
    1 - -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 Ignition Switch Key interlock switch
    5 Key interlock switch Ignition Switch
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8th - -

    [Door Lock Motor Bolt]

    No. Connector Terminal Function
    LEFT RIGHT
    1 Motor 1 -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 Ignition Switch Key interlock switch
    5 Key interlock switch Ignition Switch
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8th - Motor 1

  4. Operate the actuator by connecting power and ground as shown below to check it. To avoid damaging the actuator, apply battery voltage only for a short time.

    [Central Door Lock Motor]

    [Door Lock Motor Bolt]

    [Central Door Lock Motor]

    (LH)

    (RH)

    [Door Lock Motor Bolt]

Rear Door Lock Module Inspection

  1. Remove the rear door panel.

    (See Body - Rear Door Panel)

  2. Remove the rear door panel.

    (See Body - Rear Window Glass)

  3. Disconnect the actuator connector.

    [Central Door Lock Motor]

    No. Connector Terminal Function
    LEFT RIGHT
    1 - -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 - -
    5 - -
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8th - -

    [Door Lock Motor Bolt]

    No. Connector Terminal Function
    LEFT RIGHT
    1 Motor 1 -
    2 Motor 2 COM
    3 Motor 3 Lock/Unlock Switch
    4 - -
    5 - -
    6 Lock/Unlock Switch Motor 3
    7 COM Motor 2
    8th - Motor 1

  4. Operate the actuator by connecting power and ground as shown below to check it. To avoid damaging the actuator, apply battery voltage only for a short time.

    [Central Door Lock Motor]

    [Door Lock Motor Bolt]

    [Central Door Lock Motor]

    (LH)

    (RH)

    [Door Lock Motor Bolt]

Tailgate Lock Module Test

  1. Remove the rear door trim panel.

    (Refer to Body - "Rear Door Trim")

  2. Disconnect the actuator connectors.

  3. Operate the actuator by connecting power and ground as shown below to check it. To avoid damaging the actuator, apply battery voltage only for a short time.

  4. Tailgate power lock check applies to the rear door module.

Test yourself

A quick Kia Stonic quiz: every answer comes with an explanation and a link to the manual page.