Kia Rio YB Quiz
Body Electrical System

Front Wiper Motor

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
21steps
~126min
5/5difficulty
0102030405019.614N·mlb·ft
Tightening torque found on this page
Done 0 of 21

Components and Component Location

Component Location

1. Cap
2. Nut
3. Wiper Arm and Blade
4. Hood Top Cover		 5. Bolt
6. Wiper Motor and Linkage Assembly
7. Wiper Motor Connector

Repair Procedures

Removal

  1. Disconnect the negative (-) battery terminal.

  2. If necessary, release the wiper blade lock by pulling it upward, then remove the wiper blade from the inner side of the wiper arm.

  3. Remove the upper hood cover.

    (Refer to Body - "Upper Cowl Cover")

  4. Disconnect the wiper motor connector (A).

  5. Remove the wiper motor and linkage (A) after loosening the mounting bolts.

  6. While holding the wiper motor crank, remove the upper link (A).

  7. Remove the lower link (A) from the wiper motor crank.

  8. Remove the crank (B) after loosening the nut (A).

  9. Remove the wiper motor (A) after loosening the mounting bolts.

Installation

  1. Install the wiper motor.

  2. Install the crank.

    Tightening torque: 14.7–19.6 N·m

  3. Install the lower and upper links to the wiper motor crank.

  4. Install the wiper motor and linkage assembly, then connect the wiper motor connector.

    Tightening torque: 6.9–10.8 N·m

  5. Install the hood upper cover.

  6. Install the windshield wiper arm and blade.

    Tightening torque: 22.5 - 26 N·m

  7. Install the wiper arm and blade to the specified position.

    Auto stop position (blade)

Inspection

  1. Remove the connector from the wiper motor.

    No. Description
    1 -
    2 Battery (+)
    3 Wiper Motor (Park)
    4 Wiper Motor (High)
    5 Ground
    6 Wiper Motor (Low)

  2. Connect the positive (+) battery cable to terminal 2, and the negative (-) cable to terminal 5.

Inspection (with KDS/GDS)

  1. Electrical body system faults can be quickly diagnosed using the vehicle diagnostic system (KDS/GDS).

    The diagnostic system (KDS/GDS) provides the following information.

    1. Self-Diagnosis: Checks malfunction and Diagnostic Trouble Code (DTC)

    2. Current Data: Check the system input/output status.

    3. Actuation Test: Check the system operating status

    4. Additional function: Control of other functions, including the setting parameter system and zero point adjustment.

  2. Select "Vehicle Model" and "Body Control Module (BCM)" for inspection using the tester.

  3. Select the "Current Data" menu to view the current input/output data status.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.