Kia Rio YB Quiz
Body Electrical System

Hazard Warning Switch

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
6steps
~36min
2/5difficulty
Done 0 of 6

Repair Procedures

Inspection

  1. Check the continuity between the terminals. If continuity is not as specified, replace the hazard warning switch.

    No. Description No. Description
    1 Battery (+) 9 Illumination (+)
    2 IGN1 10 -
    3 PAB ON 11 PAB OFF
    4 Rear Center Seat Belt 12 Rear Right Seat Belt
    5 Passenger Airbag 13 Rear Left Seat Belt
    6 Hazard Mode 14 Door Lock Switch
    7 - 15 Door lock indicator
    8 Ground 16 Illumination (-)

Removal

  1. Disconnect the negative (-) battery terminal.

  2. Remove the center lower panel of the airbag.

    (Refer to Body - "Center Crash Pad Panel")

  3. Remove the hazard warning switch (A) after loosening the mounting screws.

Installation

  1. Install the hazard switch.

  2. Install the center lower airbag panel.

  3. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.