Kia Rio YB Quiz
Body Electrical System

Rear Combination Lamp

In this manual: Body Electrical System
General Information — 8Maintenance — 31Engine Mechanical System — 44Engine Electrical System — 14Emission Control System — 9Engine Control System/Fuel System — 30Clutch System — 10Manual Transmission — 10Automatic Transmission — 23Drive Shaft and Axle — 8Suspension System — 15Steering — 9Restraints — 14Brake System — 22Body (Interior and Exterior) — 115Body Electrical System — 84Heating, Ventilation, and Air Conditioning — 28
19steps
~114min
4/5difficulty
Done 0 of 19

Repair Procedures

Removal

Rear Combination Lamp (Outside)

  1. Disconnect the negative (-) battery terminal.

  2. Remove the rear combination lamp (A) after loosening the mounting screws.

  3. Remove the rear combination lamp seal (A).

  4. Disconnect the rear combination lamp connector (A).

Bulb Replacement

Turn Signal Indicator

  1. Turn off the headlamp switch.

  2. Remove the rear combination lamp (Outside).

  3. Remove the turn signal lamp (B) by turning the socket (A) counterclockwise.

Rear Combination Lamp (Inside)

  1. Disconnect the negative (-) battery terminal.

  2. Using a screwdriver or a removal tool, remove the rear combination lamp cover (A).

  3. Disconnect the connector (B) and remove the rear combination lamp (A) after loosening the nuts.

Bulb Replacement

Back-up Lamp

  1. Using a screwdriver or a removal tool, remove the rear combination lamp cover (A).

  2. Remove the back-up lamp bulb (B) by turning the socket (A) counterclockwise.

Installation

Rear Combination Lamp (Outside)

  1. Connect the rear combination lamp connector.

  2. Install the rear combination lamp.

  3. Connect the negative (-) battery terminal.

Rear Combination Lamp (Inside)

  1. Install the rear combination lamp.

  2. Connect the rear combination lamp connector.

  3. Install the rear combination lamp cover.

  4. Connect the negative (-) battery terminal.

Test yourself

A quick Kia Rio YB quiz: every answer comes with an explanation and a link to the manual page.