Displays and indicators

The presence and operation of the displays and indicators DEPEND ON EQUIPMENT AND COUNTRY.

Speedometer 1

Speedometer 1

Overspeed audible alarm

Depending on the vehicle, an audible alarm sounds for about 10 seconds every 40 seconds as long as the vehicle exceeds 120 km/h.

Note: depending on the vehicle, it is possible to program the desired speed; consult a Renault dealer.

Tachometer 2

Tachometer 2 (graduations x 1000)

Engine speed not to be exceeded in intermediate gears for economical driving: 3,000 rpm (or 2,500 rpm on diesel versions).

The presence and operation of the displays and indicators DEPEND ON EQUIPMENT AND COUNTRY.

Fuel level indicator A

Fuel level indicator A

The number of lit segments indicates the fuel level. When the level is at its minimum, the last segment lights up, accompanied by an audible signal. A warning light also comes on in the instrument panel.

Refuel as soon as possible. You have approximately 50 km of range remaining from the first illumination of the warning light.

Fuel level indicator 3

The needle indicates the fuel level.

When the level is at its minimum, the low fuel warning light comes on, accompanied by an audible signal.

Refuel as soon as possible. You have approximately 50 km of range remaining from the first illumination of the warning light.

Engine coolant temperature gauge 4 or A

During normal driving, the needle should be before zone B. It may approach zone B during intensive use. An alert is only triggered if the warning light comes on or if the message "engine overheating" appears.

The presence and operation of the displays and indicators DEPEND ON EQUIPMENT AND COUNTRY.

Engine oil level minimum warning

Minimum engine oil level alert

Depending on the vehicle, when the ignition is switched on and for 30 seconds, display A alerts you when the minimum engine oil level is reached. Refer to the "Engine oil level" section in chapter 4.

Display selection buttons 5 or 6

Display selection buttons 5 or 6

Depending on the vehicle, repeated presses of the button select the information shown on the display, and reset the trip odometer to zero (in this case, the trip odometer must be selected on the display).

• Selecting the display

A short press switches between the total odometer and the trip odometer, and vice versa.

• Resetting the trip odometer to zero

With the display set to the trip odometer, press and hold the button.

Multifunction display

Total distance traveled odometer.

Trip distance odometer.

Setting the time.

OR

Trip computer

Refer to the "On-board computer" section in chapter 1.