Front side member, front section

INTRODUCTION

This part can be replaced in two ways:

1. 1

   Complete front side member front section.

2. 2

   Partial front side member front section (cut to be made before the front cradle support), see diagram below.

In both cases, these are operations complementary to the replacement of the front lower crossmember end and the headlamp panel.

Consequently, links with these parts are not considered; they are covered in their respective sections.

Use of the repair bench is essential.

Replacing this part also requires replacing the side member closing panel, which must be ordered separately.

M.P.R. PART COMPOSITION

1 - Side member

Part assembled with:

• engine mount riser (right side only),

• front cradle support.

2 - Front side member closing panel

Part only.

LIST OF LINKS:

Side member closing panel
Front side member rear section
Front wheel arch
Shock absorber cup riser
Engine mount *

PARTS CONCERNED (thickness in mm):

1. 1

   Front side member front section 1.5

2. 2

   Front side member rear section 2.5

3. 3

   Front wheel arch 0.8

4. 4

   Shock absorber cup riser 0.8

5. 5

   Side member closing panel 1.2

6. 6

   Engine mount riser * 1.8

7. 7

   Engine mount reinforcement * 1.5

* Right side only.