Rear end cross member

INTRODUCTION

Replacing this part is a complementary operation to replacing the rear apron for a rear impact.

It is essential to replace the side member extensions (11) and (12), which must be ordered separately.

In the operation described below, you will only find descriptions of the joints specific to the part concerned.

Information on other parts is covered in their respective sections.

PART COMPOSITION M.P.R.

10 - Part assembled with rear absorber reinforcement.

11 and 12 - Side member extension

LIST OF LINKS:

Rear absorber reinforcement
Tie-down ring (left side)
Rear side member extension
Side panel gutter
Side panel inner
Rear floor
Side member

PARTS CONCERNED (thickness in mm):

1. 1

   Rear end cross member 1.2

2. 2

   Rear absorber reinforcement 1

3. 3

   Tie-down ring (left side) 1.5

4. 4

   Rear side member extension 1.5

5. 5

   Side panel gutter 1.5

6. 6

   Side panel inner 0.7

7. 7

   Rear floor 0.8

8. 8

   Side member 1.5