Front half-assembly

INTRODUCTION

Replacing this part is an operation complementary to:

• the front lower crossmember end,

• the headlamp panel

• wing side panel.

This operation requires replacing the wing side panel (footwell panel) and the upper wing side panel reinforcements, which must be ordered separately.

In the operation described below, you will only find descriptions of the links specific to the part concerned. Information on parts to be ordered separately is not included here; it is covered in their respective sections.

Use of the repair bench is essential.

M.P.R. PART COMPOSITION

Part assembled with:

1 Front side member rear section

• engine mount riser (right side)

• engine mount reinforcement (right side),

• engine mount plate (right side),

• front cradle support,

• front side member closing panel,

• wheel arch,

• shock absorber cup,

• shock absorber cup riser,

• ABS bracket (right side),

• injection unit and crash sensor bracket (left side).

2 Wing side panel (footwell panel)

3 Upper wing side panel reinforcement

LIST OF LINKS:

Heater bulkhead
Injection unit and crash sensor bracket (left side)
Front side member rear section
Shock absorber cup riser

PARTS CONCERNED (thickness in mm):

1. 1

   Heater bulkhead 1

2. 2

   Injection unit and crash sensor bracket (left side) 2

3. 3

   Front side member front section 1.5

4. 4

   Front side member rear section 1.8

5. 5

   Shock absorber cup riser 1

6. 6

   Shock absorber cup 2

7. 7

   Wing side panel (footwell panel) 1.5

   

   

   

   

   

   

Right-side specific feature.