Rear floor, rear section (partial)

INTRODUCTION

The replacement of this part is a complementary operation to the replacement of:

1 - For a side impact:

• rocker panel reinforcement,

• inner rear wheel arch,

• rear wing panel inner.

Partial replacement according to section A (see drawing and procedure below).

2 - For a rear impact

• rear apron,

• rear side member, partial or complete.

Partial replacement according to section B (see drawing and procedure below).

In the operation described below, you will only find descriptions of the joints specific to the part concerned.

Information on other parts is covered in their respective sections.

Use of the repair bench is essential.

PART COMPOSITION M.P.R.

Part assembled with tie-down ring reinforcement.

LIST OF LINKS:

Side floor
Upper shock absorber gusset
Rocker panel closing panel
Rear axle mounting box
Upper shock absorber mounting reinforcement
Rocker panel closing panel, rear section
Rear floor cross member, front section
Rear side member
Wheel arch
Bump stop mounting
Rear floor stiffener
Centre cross member

PARTS CONCERNED (thickness in mm):

1. 1

   Rear floor, rear section 1

2. 2

   Side floor 0.8

3. 3

   Upper shock absorber gusset 1.5

4. 4

   Sill closing panel 1.2

5. 5

   Rear axle mounting box 1.2

6. 6

   Upper shock absorber mounting reinforcement 1.2

7. 7

   Rear section sill closing panel 1.5

8. 8

   Rear floor cross member, front section 0.8

9. 9

   Rear side member 1.5

10. 10

    Wheel arch 1

11. 11

    Bump stop mounting 1.5

12. 12

    Bump stop mounting reinforcement 1.5

13. 13

    Rear floor stiffener 1

14. 14

    Centre cross member 1.5

15. 15

    Rear floor, front section 0.8

1 - ACCORDING TO SECTION A

2 - ACCORDING TO SECTION B